deer string art

The past few months have been nothing short of chaotic, and it’s been a while since I’ve had time to finish a craft. Deadlines and to do lists take priority over “create” these days. And despite all of this, I couldn’t get past the nagging feeling that I need to complete something that: 1. I’ve made with my hands and 2. Is beautiful.

Deer String Art

I saw this deer string art months ago on this blog and went out immediately to buy the supplies. Since then, I’ve taken my sweet time hammering in a few nails here and there, but never really committing to complete the project. Then yesterday, something just snapped and I knew I couldn’t do anything else without finishing it. So, I spent an hour or so hammering away (pun intended). I’m so glad I did! It is probably my favorite d.i.y. project I’ve made.

Deer String Art

The supplies:
– 1 round cross-cut wooden plaque
chalkboard paint
1 inch wire nails (project nails), I bought a 100 pack, but didn’t use them all.
– finishing hammer
– embroidery floss or string (I used string, but I’ve seen this done with embroidery floss)
– paper and pencil for tracing

I used this silhouette for the deer stencil. You can enlarge it to the size you want and then print it out. Or in my case, I just held a sheet of paper against the computer screen and traced it.

Coat the wood plaque with two coats of chalkboard paint. Let it set overnight to dry.

Place your pattern in the center of the plaque. You can add a piece of tape to secure it.

Take your nails and hammer them into the plaque along the edge of your silhouette. I found it was easiest to make them a thumbs-width apart. This makes it easier to hold the nails anyway. To create the fine edges around the antlers, you’ll have to place the nails closer together.

deer string art

Once they’re all nailed in, remove the paper stencil and tie the ends of the embroidery floss around a nail. Wrap your embroidery floss around the edges until you’ve outlined the entire thing. Then continue to fill in the middle, hooking the floss around opposing nails.

Deer String Art

Once you’ve filled in the center, tie off the string on a nail. That’s it, you’re done. The nailing can be tedious, but it’s well worth it.

I just love the way this looks. It turned out way better than I expected. i wasn’t sure if I was on board with the string art craze, but now I’m sold. What do you think?

Love it? Pin it here!


11 thoughts on “deer string art

Leave a Reply

Your email address will not be published. Required fields are marked *